Pre-wired and tested with all of the BlueROV2 electronics, this enclosure is ready-to-integrate into your custom ROV frame or other application.
Lead time is currently 2-3 weeks.
Description
This product includes the enclosure and electronics from the BlueROV2, pre-wired and ready to go! This is an excellent option if you are building a custom ROV frame and need a ready to use electronics and control solution! Includes topside Fathom-X tether interface and a few extra blank penetrators to fill any unused penetrator holes.
Contents
4″ Series Enclosure
1 x Cast Acrylic Tube – 11.75″, 298mm (4″ Series)
2 x O-Ring Flange (4″ Series)
1 x Dome End Cap (4″ Series)
1 x Aluminum End Cap with 14 Holes (4″ Series)
1 x Enclosure Vent and Plug
Advanced Electronics
1 x Raspberry Pi 3 Computer
1 x Raspberry Pi Camera with Wide Angle Lens
1 x 8 GB SD Card Preloaded with Raspbian for ArduSub
1 x 6″ Left-Angle Micro USB Cable for Raspberry Pi to Pixhawk
1 x UBEC Power Supply for Raspberry Pi
1 x Pixhawk Shelf and Mounting Hardware
1 x XT60 Male to Spade Cable (for Pixhawk Power Module)
1 x XT60 Female to Bullet Connector Cable (for Pixhawk Power Module)
1 x Ferrule to Spade Cable (for Fathom-X)
Electronics Tray
1 x Tray (ABS)
1 x Front Bulkhead (ABS)
1 x Rear Bulkhead (ABS)
4 x Short Hex Standoffs
2 x Long Hex Standoff
4 x Standoff Screws
4 x Computer Mounting Screws
4 x Computer Mounting Standoffs
10 x Small Zip Ties (Cable Routing)
3 x ESC Zip Ties
2 x 8-Circuit Barrier Block
14 x Barrier Block Jumpers
2 x Barrier Block Mounting Nuts
2 x Barrier Block Mounting Screws
2 x 9-Circuit Eurostyle Terminal Strip
8 x Eurostyle Terminal Strip Mounting Screws
4 x Eurostyle Terminal Strip Mounting Standoffs
Other
6 x BlueROV2 Basic 30A ESC
1 x Bar30 Sensor
7 x Blank Penetrators
1 x BlueROV2 Power Cable
1 x HS-5055MG Servo
1 x SOS Set