T200 Thruster with Penetrator (BlueROV2 Spare)
- 1 x T200 Thruster w/ Cable Penetrator
- 1 x Cable Penetrator Nut
- 1 x Cable Penetrator O-ring
- 1 x CW or CCW Propeller
|Full Throttle FWD/REV Thrust @ Nominal (16 V)||5.25 / 4.1 kg f||11.6 / 9.0 lb f|
|Full Throttle FWD/REV Thrust @ Maximum (20 V)||6.7 / 5.05 kg f||14.8 / 11.1 lb f|
|Minimum Thrust||0.02 kg f*||0.05 lb f*|
|Operating Voltage||7-20 volts|
|Full Throttle Current @ Nominal (16 V)||24 Amps|
|Full Throttle Current @ Maximum (20 V)||32 Amps|
|Full Throttle Power @ Nominal (16 V)||390 Watts|
|Full Throttle Power @ Maximum (20 V)||645 Watts|
|Length||113 mm||4.45 in|
|Diameter||100 mm||3.9 in|
|Weight in Air (with 1m cable)||0.76 lb||344 g|
|Weight in Water (with 1m cable)||0.34 lb||156 g|
|Propeller Diameter||76 mm||3.0 in|
|Mounting Hole Threads||M3 x 0.5|
|Mounting Hole Spacing||19 mm||0.75 in|
|Cable Length||0.71 m||28 in|
|Cable Diameter||6.3 mm||0.25 in|
*Values limited by ESC used to drive thruster.
Note that nominal operation at 12-16 V is recommended for the best balance of thrust and efficiency, though operation at up to 20 V is allowable. Exceeding 20 V is not within the rating and not recommended, please see here for more information.
For more detailed performance specifications, including thrust, RPM, power, and efficiency at various throttle levels and supply voltages from 10-20 V, please see the performance charts below.
All the raw data and notes on the testing procedure used to generate these charts can be downloaded here:
1. Connect motor wires to ESC and connect the ESC to power and a signal.
2. Send a signal and the thruster will start spinning. That’s it.
Always practice caution when you’re working with electricity in water and with the spinning blades of the propeller. Keep body parts away from the thruster inlet and outlet to avoid injury.
Do not operate the thruster for extended periods out of water. The bearings are lubricated by the water and vibration and noise will be greater when dry.
Do not use threadlocking compounds like Loctite on any part of the thruster. It will damage the plastic and cause it to become brittle.
The thruster can handle saltwater environments pretty well, but it does not get along with seaweed. Avoid sucking seaweed into the thruster to avoid damage.